Radar Speed Zoning
TRANSMON RADAR BASED SPEED ZONING
TRUCK BASED SPEED ZONING FOR INDOOR / OUTDOOR APPLICATIONS
Transmon Engineering now have a radar based speed zoning option. This truck mounted sensor in slimline and unobtrusive and is ideally mounted on the roof of the forklift truck. The sensor detects roof height so will know when the forklift truck is indoors and when it is outdoors.
The sensor works via roof height detection without being obscured by outdoor objects such as overhead cranes. The sensor then communicates with either the trucks on board speed control or one of our own designed and manufactured speed controls: RSPC1 - for mechanical speed control or iTEch control - for electronic throttle pedals. This will then allow the truck to have 2 safety spe
Red LED Line Alert
FURTHER ENHANCE SITE SAFETY BY PROVIDING A VISUAL WARNING TO PEDESTRIANS
Our range of forklift truck safety lighting is ever expanding the already successful blue LED spot light has now been partnered with our red LED side line alert.
Transmon now offers a bright rugged and flexible red LED line light which provides a visual warning alerting pedestrians that they are too close to the forklift truck. The system is ideally suited to trucks operating in warehouse aisles or unclear cross-over areas and for operations requiring pedestrians and forklift trucks to operate safely alongside each other.
The light is resistant to shock vibrations and moisture and the LED technology offers high light output while maintaining a low current draw.
Unlike audible warning devices pedestrians and other drivers can see instantly where the trucks is and in which direction it is travelling and many drivers and employees have expressed an improved accep
Road Speed Control
ENHANCES SITE SAFETY BY LIMITING THE FORKLIFT TRUCKS TRAVEL SPEED
This product conforms to
The new iTEch Speed v2 has been designed to limit the travel speed of a forklift truck with a cable-operated throttle by detecting that the truck is travelling above a pre-set speed and then applying a throttle restriction to limit the truck speed. As long as the truck is travelling below the pre-set speed lifting is not affected.
The unit can be programmed with two separate speeds which can be switched by for example the directional selector (giving a slower speed in reverse than forward) a key switch where the Supervisor holds the key or our iTEch Zone or Proximity Alert systems. Due to its ability to give a proportional restriction (where if the speed begins to drop the limit is relaxed gradually) the climbing of
Sequential Seat Belt System
INCREASES SITE SAFETY BY PROMPTING THE OPERATOR TO CONNECT THEIR SEAT BELT OR DRIVE WILL BE PROHIBITED
The Sequential Seatbelt Startup System is designed to alert the operator if the seatbelt is not connected or has been disconnected during use. It can also be used to disable vehicle functionality such as interrupt drive or prevent vehicle ignition.
An audible buzzer and a visual lamp are mounted in the cab to alert the operator. Off truck personnel are alerted via an external flashing red beacon.
The only means of deactivating the warning during use is to replace the seatbelt strap in to the clasp. The warning devices all remain active whilst the seatbelt is not fastened and the truck is in use.
Seat belts can also be used in conjunction with our TDS601 fleet management system which has the ability to enforce correct seatbelt use and record non-compliance.
The system uses the following method to determine whether the seat b
HELPS TO ENHANCE SITE SAFETY THROUGH DRIVER ACCOUNTABILITY BY RECORDING DRIVING INCIDENTS
A vehicle-mounted camera and recording unit enables management to review incidents that have occurred in the work place automatically storing the recorded footage from shortly before the impact to shortly after.
A simple USB connection allows a fast data download using any PC or laptop and the footage can be viewed in detail using the supplied software.
- Wide-angle lens
- Impact or button press triggers capture of 15 seconds before and 15 seconds after incident
- Optional continuous recording mode for 2 - 16 hours (depending on memory card capacity)
- On-board GPS provides location speed plots the event and shows route<
Speed Safety Zone
ENHANCES SAFETY BY RESTRICTING FORKLIFT TRUCK TRAVEL SPEEDS IN DESIGNATED ZONES
This system offers safe speeds in designated areas whilst keeping productivity at a maximum in lower risk areas. Each gate or exit has a fixed transmitter which can be fitted in various configurations depending on the site requirements. Each truck has a receiver which can trigger additional functionality when it passes a transmitter - when the truck enters the zoned area the system automatically switches to controlled operation and switches back automatically to normal operation when the truck leaves again. In case of any faults or tampering the system can be programmed to default to slow speed.
- Can be fitted to any vehicle
- Defined zoned areas
- Robust design
- Easily extendable to additi
TDS1 RFID entry
THE TDS1 DRIVER ACCESS UNIT INCREASES SAFETY THROUGH CONTROLLED ACCESS AND DRIVER AND TRUCK MONITORING
Provided by our partner in the US Keytroller the TDS1 is a tried and tested keypad which has been adopted by some of the largest forklift truck manufacturers suppliers and users in the world. It provides management information about the fleet assisting logistics professionals in managing their materials handling operation more effectively.
Drivers can log in via a manual key code (4 digits) or an RFID fob available at additional cost.
The system records the driver and truck`s activity which can be downloaded via RS232 onto a laptop/PC. The data can then be reported on to equip fleet managers with information about the truck usage any impacts and more.
TRANSMON VISION SYSTEM
ENHANCES SITE SAFETY AND EFFICIENCY WHEN WORKING AT HEIGHT BY IMPROVING VISIBILITY
The system offers excellent visibility to the operator from a standard driving position. The camera is located on the vehicle and focuses on the area of sight required with an automatic iris compensating for the change in lighting conditions.The pictures sent live to the TFT 7" colour flat screen located in an unobtrusive position allow the driver to make adjustments to lifting or reversing directions.The system enhances health and safety levels reducing the amount of damage caused by miscalculations made due to human error. Ideal for vehicles operating at height the system is multi-voltage and will also work in cold stores as well as in yards.
Shielded Wired Video Connection Powered from Vehicle
Wireless Fork Mounted Camera
TRANSMON WIRELESS FORK MOUNTED CAMERA
WIRELESS FORKLIFT CAMERATransmon Engineering Ltd now offer a unique driver aide. Our wireless fork mounted camera enables the driver a true `fork-eye` vision of the front of the forklift truck. This unique perspective aids drivers by assisting with loading and unloading as well as ensuring the correct fork position when dealing with high level racking and off loading from vehicles.
The fork mounted camera attached magnetically to enable easy installation as well as re positioning should you require. This magnetic application also helps to minimize damage if there is an accident. The fork camera sends live feed pictures to a 7 inch colour screen monitor mounted unobtrusively within the forklift